Publicidad
Idiomas disponibles
Idiomas disponibles
User Manual
Network Page:
Here you can switch the IP settings between static and DHCP as well as the Telnet Port. It also allows
the change of the passwords and the reset of the network settings.
System Page:
Here you can set various settings like locking the front panel, turning on/off the confirmation sound of the
push buttons, shut-down time for the front panel and the Baud Rate for the serial control. This page is also
used for firmware updates, factory reset and reboot of the unit.
RS-232 Control
This matrix also supports control over RS-232 using ASCII commands. Firstly, connect the matrix to a PC
with a RS-232 to USB cable. Then open a serial command tool to enter all required commands.
Serial Port Control: Baud rate(default): 115200
Data bits: 8
Stop bits: 1
Check bit: 0
RS-232 Command
s power z!
r power!
s reboot!
help!
r type!
r status!
r fw version!
r link in x!
r link out y!
Function
Power on/off the device,z=0~1
(z=0 power off, z=1 power on)
Get current power state
Reboot the device
List all commands
Get device model
Get device current status
Get Firmare version
Get the connection status of the
x input port, x=0~8(0=all)
Get the connection status of the
y output port, y=0~8(0=all)
Feedback
Power on
System Initializing...
Initialization Finished!
power off
power on/power off
Reboot...
System Initializing...
Initialization Finished!
FW Version x.xx.xx
Get the unit all status:
power, beep, lock, in/
out connection, video/
audio crosspoint, EDID, scaler,
network, status
MCU BOOT: Vx.xx.xx
MCU APP: Vx.xx.xx
WEB GUI: Vx.xx
HDMI Input 1: connect
HDMI Output 2: connect
English
Publicidad
