Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Problem
Possible Causes
Dishwasher
Fuse blown, or the
will not start.
circuit breaker tripped
Power supply is not
turned on.
The door has not
been properly closed.
Water not
Kink in drain hose
pumped from
Filter clogged
dishwasher
Kitchen sink clogged
Suds in the tub Improper detergent
Spilled rinse aid
Stained tub
Detergent with
interior
colourant is used.
White film
Hard water minerals
over the inside
surface
There are rust
The cutlery is not
stains on the
corrosion resistant.
cutlery.
No programme has
run after dishwasher
salt was added.
Traces of salt have got
into the wash cycle.
Solutions
Replace fuse or reset circuit breaker.
Remove any other appliances sharing
the same circuit with the dishwasher.
Make sure the dishwasher is turned on
and the door is closed securely.
Make sure the power cord is properly
plugged into the wall socket.
Close the door securely.
Check drain hose.
Check the filters (see "Cleaning the
Filter Unit").
Check kitchen sink to make sure it is
draining well. If kitchen sink is not
draining, you may ask a plumber to
check it.
Use only the detergent special for
dishwasher to avoid suds. If this occurs,
open the door and let the suds
evaporate. Close the door securely
then start the soak wash cycle to drain
the water out. Repeat if necessary.
Always wipe up rinse aid spills
immediately.
Make sure the detergent does not
contain any colourant.
To clean the interior, use a damp
sponge with dishwasher detergent and
wear rubber gloves.
Never use any other cleaner than
dishwasher detergent for the risk of
foaming or suds.
Always run the rapid washing
programme.
Add dishwasher salt with no crockery in
the dishwasher.
21
Publicidad
