BaByliss PRO 4rtists FX8705E Manual Del Usuario página 9

directly onto the blades.
• Leave the unit on for a further
few seconds to allow the oil to
thoroughly spread along the
length of the blades.
• Switch off the unit and remove any
excess oil by gently dabbing with
a cloth before using on hair.
Comb guides:
• To attach a comb guide, ensure the
appliance is switched off. Position
the comb guide over the front of
the clipper blade and slide over
the head. Push and click the rear of
the comb guide into position.
• To remove the comb guide, ensure
the appliance is switched off. Push
the tab on the rear of the comb
guide away from the head and
lift off.
INSTRUCTIONS FOR USE
Charging the appliances
• Before using the clipper/trimmer
for the first time, charge the
batteries continuously for 3 hours.
Maximum battery capacity will
only be reached after 3 completed
charging and discharging cycles.
• Connect the charging cable into
the back of the charging stand.
Plug into a suitable mains power
socket and switch on. Place the
clipper and trimmer into the
dual charging stand. The red LED
indicator light will flash when
correctly placed into the stand
and will continuously flash until
the battery has fully charged.
When the batteries are fully
charged the LED indicator light
will stop flashing but remain on.
NOTE: Always place the clipper/
trimmer in the base with the 'I/0'
switch in the 0/OFF position.
• When the clipper/trimmer is
running low on charge, the LED
indicator light will flash, warning
there is approximately 3 minutes
of battery use remaining. A 3 hour
charge will provide approximately
120 minutes use. A 30 minute quick
charge will provide approximately
30 minutes use.
• If the charging light starts to
flash rapidly (more than 4 flashes
per second) then the appliance
is faulty. If this happens then
please stop charging and remove
the adapter from the mains and
contact the customer care service.
Preserving the Batteries
• In order to maintain the optimum
capacity of the rechargeable
batteries, the appliance should
be recharged
approximately every 3 months.
• Using the clipper/trimmer on the
mains - ensure that the clipper/
trimmer is switched off. Plug into
a suitable mains socket. Wait for
approximately a minute, and then
switch on.
IMPORTANT: Do not use the
clipper/trimmer in this mode for
more than 20 minutes.
9
for 3 hours