Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
STARTING AND STOPPING THE PRESSURE WASHER
C A U T I O N
Do not run the pump without the water supply connected and turned on.
•
Connect the garden hose.
•
Turn the water supply on, then squeeze the trigger and run water hose with motor in OFF
position until a steady stream of water appears. This helps drain air from tank and lines.
NOTE: If the pressure washer pulsates and the water stream is intermittent turn the pressure
washer off and continue to bleed air out of the system. Ensure to check that the garden hose is
fully turned on and not kinked.
•
After ensuring the On/Off switch is in the OFF ( O ) position, connect the pressure washer
to the power supply.
•
Press the reset button on the pressure washer's plug to make sure the unit is ready for
operation.
•
Set the switch to the ON ( I ) position to start the motor.
•
To stop the motor, release the trigger and press the switch to the OFF( O ) position.
NOTE: The pressure washer may be on and the system may have pressure even when the
pump and/or motor cannot be heard running. Always use caution around the pressure washer.
C A U T I O N
Hold the trigger handle securely with both hands. Expect the trigger handle to move when the
trigger is pulled due to reaction forces. Failure to do so could cause loss of control and injury to
yourself and others.
NOTE: AUTO ON/OFF SWITCH: This pressure washer is equipped with an auto start/stop
feature. To operate: Set the power switch to the On (I) position. Pump will pressurize and shut
down immediately. Once the trigger of the gun is depressed, the unit will turn on. Unit will shut
off and be in standby mode when trigger is released.
See Figure 10.
ON/OFF Switch
17
Fig. 10
Publicidad
