Descargar Imprimir esta página

Amica WK 341 S Serie Manual De Instrucciones página 18

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 93
Optimal temperature selection
Whilst wine is best stored at temperatures between 13 and 15˚ C, your
wine can also be stored at drinking temperature. For red wine this is be-
tween 15 and 17˚C, and for white wine between 12 and 13˚C.
To use the internal light
Press the light button to switch the light on or off.
Note: The temperature in the lower zone must be set either the same
as or higher than the temperature in the upper zone. For optimal perfor-
mance, the temperatures in the two zones should differ by at least 4˚C.
Internal Humidity
According to the model wine coolers are equipped with a humidity sys-
tem to maintain optimal humidity within the wine cooler. Fill the humidity
reservoir approximately 3/4 full with water. Place the reservoir on the
runners on the top shelf as shown in fig. 2. Ensure it is located correctly
to prevent water spillage. Check the water level regularly and refill if
required.
Temperature display
The temperature display will show the current internal temperature.
The display flashes:
When a different temperature is being set
If the internal temperature is +/- 5˚ away from the set temperature.
This serves as a warning to prevent damage to the contents of the appli-
ance should the temperature be too high.
Silent mode
Once the required temperature is reached, the appliance will run without
the fan. The wine cooler is factory set to silent mode. To change to dy-
namic cooling mode, touch and hold the "-" button for approximately five
seconds (left hand "-" button on 2-Zone coolers). The wine cooler will
beep five times to confirm dynamic cooling is on.
Dynamic cooling mode
The fan cycles on and off to circulate the air even after the required tem-
perature is reached. This ensures consistent humidity and temperature
distribution in the wine cooler, creating perfect conditions for long term
storage.
Using the dynamic mode increases the level of noise in operation.
To change to silent mode, touch and hold the "+" button for approxi-
mately five seconds (left hand "+" button on 2-Zone coolers). The wine
cooler will beep three times to confirm silent mode is on.
- 18 -

Publicidad

loading