Publicidad
Idiomas disponibles
Idiomas disponibles
Lock-button: Press the button for about 3-5 seconds to unlock the device.
After approximately 10-15 seconds without operation it locks automatically. Press the button
again to unlock the device.
Start/Stop-button: Start and stop the dispense of water.
13.3 Rating plate
The rating plate with the connection and performance data can be found beneath the device.
14 Operation and Handling
This chapter provides you with important notices with regard to operating the device. Observe
the following notices to avoid dangers and damages.
► Do not leave the device unsupervised during operation.
14.1 Before initial use
14.1.1
Preparation of the waterfilter
1. Remove the waterfilter from all packaging. There may be a small residue of black carbon
particles in the bag or on the filter body. This is normal. These particles are harmless and
will be washed off during the preparation process.
2. Soak the waterfilter upright in water for 10 min.
3. Rinse the waterfilter thoroughly under running water.
4. The waterfilter is now ready for use.
► The lifetime of the waterfilter lasts about 4-6 weeks of normal use (filtering of
approximately 150 l water in total).
► Store the replacement filters in a cool location, out of direct sunlight and away from heat
sources.
14.1.2
Preparation of the device
1. Place device without drip tray.
2. Fill the tank up to max marking.
3. Place vessel below the spout which can collect whole content of watertank.
4. Start the device with 000 temperature setting until ca. 300 ml water is dispensed.
5. Turn to 100°C temperature setting with continuous water flow and let the device dispense
water.
6. When device shows Lo Lack of water (watertank is empty), then the process is finished.
7. The device can now be equipped with waterfilter and filled with fresh water.
8. The device is ready for use.
Warning
Please note
36
Publicidad
