Descargar Imprimir esta página

Hkoenig BOE40 Manual De Uso página 5

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 25
All manuals and user guides at all-guides.com
start timing, about10 seconds later, LCD without any display. If press '+' or '-', and press 'I/O' again,
electronic board will reset the work.
2. Insulation functions
Open the lid and full water (not more than the maximum water level 1. 8 L and cannot be less than
minimum water level 0. 8 L), then put on the lid..
Connected the power, the pot body into the power base. Now nothing appear in LCD , which means
the kettle is on standby .When the kettle on standby, only can use the'I/O', you can use '+' and '-'
Highest heat preservation temperature can only be set at 90 ℃ : when the set temperature and actual
buttons.
water temperature is higher than 90 ℃, then press '
pressed, and set the water temperature as 90 ℃, and then press '+' button will not work.
'button will not work; When '
' button has been
Method 1: firstly, press '+' or '-', LCD show 40℃, then press '+' or '-' button and set heat preservation
temperature, press '
' keep warm Button, and then press 'I/O' again, LCD and the
sign under the
LCD on right keep flashing. The kettle is into the preservation and began to boil water. At this time, if
not press 'I/O', LCD and and the dot under the LCD on right will not flash, after 10 seconds, the LCD
no display, kettle back to standby.
Method 2: you can press '
' , and then press the ' + 'or ' - ' button and set preservation temperature,
and then push the 'I/O' heat preservation, LCD and the
sign under the LCD on right keep flashing,
The kettle is into the preservation and began to boil water.
In the process of boiling water, press '+' or '-', can reset the heat preservation temperature. When set
temperature is higher than the actual water temperature, continue to boil water; When the actual water
temperature is up to the set temperature, the heating tube will not work, and electronic board start the
time, about 4 hour later, LCD no display, which means the kettle back to standby. When, after LCD no
display, the kettle back to standby mode.
When the boiling water temperature is up to the set temperature, then heat pipes stop working, and
the kettle began to heat preservation.
When the water temperature lower than the set temperature, heat pipes began to heat and up to
setting temperature, and LCD and the
sign under the LCD on right keep flashing. When the water
temperature is equal to or higher than the set temperature, the heat pipe does not work, in the
insulation state, LCD and the
sign under the LCD on right will not flash, and repeat.
In the process of heat preservation, if press
key to exit heat preservation function, return to boil
water.
When entered into the state of thermal insulation, electronic board start time, about 4 hour later, the
LCD no display, then the kettle back to standby Within an hour, press 'I/O', LCD no display, the kettle
back to standby.
HOW TO CLEAN KETTLE
1. Please unplug the power plug and let the pot become cool before cleaning.
2. Please do not immerse the kettle, power cord, power plug and power socket into water.
3. Please ensure the electronic line circuit dry.
4. Please wipe the kettle body with a damp cloth. Please do not use scouring powder, cleaning
ointment product, they will damage the surface characteristics of kettle.

Publicidad

loading