Publicidad
Step 2
Separate the EXTENSION SLIDES (K) from the EXTENSION
å
RAILS (J) as shown in the enlarged diagram below. Be
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (J) to the ENDS (A and B). Use
å
eight GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to fi nd the other hole that
lines up with the hole in the END. Turn a SCREW into this hole.
Edge with
TWIST-LOCK®
FASTENERS
Open end
Page 6
K
Push the black lever in and pull the SLIDE from the RAIL.
Edge with
TWIST-LOCK®
FASTENERS
J
B
J
This hole
must be here.
J
A
419610
3S
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
J
J
This hole
must be here.
www.sauder.com/services
Open end
Publicidad
