Publicidad
Idiomas disponibles
Idiomas disponibles
3
PREPARATION FOR PUTTING INTO OPERATION
3.1
UNPACKING AND INSPECTING THE CONTENTS
This chapter primarily serves the needs of the vendor's mechanics that prepare the mower for the user within the scope of pre-sale
service. In the event that you have received your mower already assembled and ready for operation, please skip directly to chapter 4.
In the event that you have unpacked the mower yourself, then it is necessary to prepare it for operation according to the instructions
contained in this chapter. In the event that you are unsure about the procedure or you have insufficient equipment, tools or experience,
please do not hesitate to contact the vendor of the mower for assistance.
We recommend performing all assembly works in a team of at least two people.
Inspect immediately after delivery that the packed mower has not been damaged. In the event of damage inform the carrier. If the
complaint is not lodged in time, no potential demands can be claimed.
Check that the mower model is the same as you ordered. In the event of an irregularity do not unpack the mower and immediately
report this discrepancy to the supplier.
In the packaging you will find:
(1) Crate cover
(2) Ramps (attention – these are not included!)
(3) Steering wheel
(4) Seat
3.1
(5) Documentation (packed parts list, user's manual for the riding mower, user's manual for the engine, user's manual
for the battery, service log book)
(6) The grass catcher (is partially disassembled in a cardboard box, with a hitch and joining material.
UNPACKING
1.
Using a suitable tool (e.g. crowbar or hammer, etc.) remove the crating (1), take out all the individually packed assemblies and
remove all reinforcing elements and packaging materials.
2.
Visually inspect the mower for damage that may have occurred during transport. Also unpack all individually packed assemblies
and inspect them. In the event of any type of damage, immediately contact the supplier and do not continue with the installation
of the mower.
3.
Prepare suitable ramps (
damaging parts of the mower.
4.
Lift the mowing deck into the transport position by pulling the lever to the highest position (
deck, there is a risk of seriously damaging it.
3.2
DISPOSAL OF PACKAGING MATERIALS
After unpacking everything, ensure that the packaging material is properly disposed of or recycled. The disposal must
conform to relevant waste disposal laws valid in the user's country.
Disposal may be performed by a specialised company.
3.1, position 2) to drive the mower from the pallet. If you do not use ramps there is a danger of
85
4.2). If you do not lift the mowing
Publicidad
