EuroLite TS-10 Manual Del Usuario página 27

Control Board
The Control Board offers several features: you can e. g. simply set the starting address.
Browse through the menu by pressing Menu Up or Menu Down. You can change the selection by pressing
Up or Down. You can leave every mode by pressing the Menu-buttons. The functions provided are described
in the following sections.
After you connected the effect to the mains, the display shortly indicates "---" followed by:
Main menu
001-512
d001
0 - positiv
t-0
1 - reverse
0 - positiv
p-0
1 - reverse
n-1
s-1
DMX-controlled operation
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the TS-10 will respond to the controller.
If you set, for example, the address to channel 7, the TS-10 will use the channel 7 to 12 for control.
Please, be sure that you don't have any overlapping channels in order to control each TS-10 correctly and
independently from any other fixture on the DMX-chain.
If several TS-10 are addressed similarly, they will work synchronically.
Press the Menu-buttons and the Up/Down-buttons for setting the desired starting address. Now you can start
operating the TS-10 via your lighting controller.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
Display Function
With this function, you can adjust the desired DMX-address via
the Control Board.
With this function you can reverse the Tilt-movement.
With this function you can reverse the Pan-movement.
Sound-controlled mode when there is no DMX signal and that
n-1
the device is defined as master.
Automatic program mode when there is no DMX signal and
n-2
that the device is defined as master.
Neutral position (is only meant for service-purposes) and that
n-3
the device is defined as master.
s-1
s-2
With this function, you can define the device as slave.
s-3
s-4
27/57 00031630.DOC, Version 1.0