Publicidad
Idiomas disponibles
Idiomas disponibles
SECTION 5 – INSTALLATION
5.1 Installing the Spool Gun
Connect the gun to the welding machine.
1. Power "OFF" the welder.
2. Fully insert gun cable back end connection (welding power and gas supply).
3. Plug P6 amphenol connector leads (male connection) into the P6 amphenol connector
(female receiver) on the machine and turning until it is located in the position.
4. Switch the gun selector inside the welder to Spool Gun option.
5.2 P6 Connector Pin-out
(See Table 3 and Figure 4)
Pin No.
1
2
3
4
(See Figure 2)
Function
Trigger
Trigger
+ Motor
- Motor
Table 3
Figure 4
EN-9
Gun Cable Lead Color
Yellow
Green
Red
White
Publicidad
