Garland GEISER 693 Q Manual De Instrucciones página 26

English
5. Check that the oil level is between the minimum
and maximum levels.
If the oil level is close or below the minimum level,
refill oil until the oil level is close to the maximum
level.
ATTENTION!: The engine of this machine has
a security device incorporated that avoids the
machine working with little oil. If the oil level is too
low the engine will stop and it will not restart until the
oil level is again above the minimum level.
6.3.3. PETROL
Check that there is enough petrol in the petrol deposit
and refill if necessary. To refill with petrol:
1. Choose an adequate area and surface to refill
petrol.
2. Remove the petrol cap.
3. Refill with petrol but never surpassing the level of
the petrol filter that is in the entrance of the petrol
deposit. If petrol covers the petrol filter, petrol could
leak out when the petrol heats up and expands.
4. Screw the petrol cap tightly.
5. Eliminate all the petrol that
could have leaked out
with a dry rag.
WARNING:
- Stop the engine before refilling.
- Do not refill in a closed area or with very little
ventilation.
- Do not smoke when refilling.
- Move the machine at least 3 metres from the
refilling area before starting the machine. Always
use unleaded 95 octane petrol.
6.4. START UP AND STOPPING THE MACHINE
6.4.1. WATER PRIMING
Fill up the water circuit of
the machine. Make sure
the machine is filled up with
water before starting the
machine. If not, there could
be breakages.
The water level should reach the superior part of the
body of the machine as shown in the figure.
6.4.2. START UP OF THE ENGINE
Follow the instructions of cold or hot start up
depending on the state f the machine.
ATTENTION! Before starting, make sure the fuel
tap is in open position.
6.4.2.1. COLD START UP
a. Place the switch in the ¨I¨ position.
b. Put the air lever in the close position
c. Move the lever accelerator to the high position.
d. Pull the starter rope until the engine starts.
e. Move the air lever gradually to the open position
Accelerator
6.4.2.2. HOT START UP
a. Place the switch in the ¨I¨ position.
b. Put the air lever in the open position
c. Pull the starter rope until the engine starts.
26/100
.
.
High
Low
.