LF allen + roth RIAN SU-WW 5288438 Instrucciones De Montaje página 6

ASSEMBLY INSTRUCTIONS
1. Place the tip-over restraint (DD) on the wall at a proper height,
mark the positions of the holes onto the wall.
WARNING: Customer must install the tip-over restraints provided.
Serious or fatal crushing injuries can occur from furniture tip-over.
Use of tip-over restraints may only reduce, but not eliminate, the risk
of tip-over.
• 2. Gypsum wallboard or concrete walls: Drill pilot holes in the
marked locations with a ø 5/16" (8 mm) drill bit. Insert the wall
anchors (AA) using a rubber mallet until the wall anchors are flush
with the wall.
• 2. Solid wood walls: Drill pilot holes in the marked locations with a
ø 1/16" (2 mm) drill bit. Wall anchors are not necessary.
3. Install the tip-over restraint onto the wall with screws (BB).
1
DD
2
ø5/16"
8mm
3
DD
AA
BB
PAGE 6