Publicidad
Idiomas disponibles
Idiomas disponibles
Tool Specifications
Orbital sander
Part number
Rated power
Output power
No-load speed
Oscillations
Oscillation range-Ø
Sanding plate
Sanding sheet:
- Velcro attachment
- Clamping attachment
Integral dust extraction
Weight without cable, approx. 1.3 kg
Protection class
Noise/Vibration Information
Measured values determined according to
EN 50 144.
Typically the A-weighted sound pressure level of
the tool is 75 dB (A). The noise level when work-
ing can exceed 85 dB (A).
Wear ear protection!
The typical weighted acceleration is 3.5 m/s
Use as Intended
The machine is intended for the dry sanding of
surfaces of wood, plastic and filler as well as for
painter surfaces.
Operating Controls
1 On/Off switch
2 Sanding plate
3 Sanding sheet
4 Clamping lever
5 Adapter
6 Paper dust bag
7 Vacuum socket
8 Plug*
9 Punching tool*
10 Tissue dust bag*
* Not all of the accessories illustrated or described are
included as standard delivery.
BTI-SW 16 A
015869
150 W
70 W
12 000 rpm
-1
24 000 min
2.4 mm
80 x 130 mm
80 x 133 mm
80 x 166 mm
•
/ II
2
.
English - 1
For your Safety
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed.
Wear safety goggles.
The dust that is produced while working can be
detrimental to health, inflammable or explo-
sive. Suitable safety measures are required.
Examples: Some dusts are regarded as carci-
nogenic. Use suitable dust/chip extraction and
wear a dust respirator.
Dust from light alloys can burn or explode. Al-
ways keep the workplace clean, as blends of
materials are particularly dangerous.
If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Use only
extension cables that are approved for outdoor
use.
The machine can be used only for dry sanding.
Insert the mains plug only when the machine is
switched off.
Always direct the cable to the rear away from
the machine.
Do not work with materials containing asbes-
tos.
Always switch the machine off and wait until it
has come to a standstill before placing it down.
Never allow children to use the machine.
BTI is only able to ensure perfect operation of
the machine if the original accessories in-
tended for it are used.
Publicidad
