Teac TN-5BB Manual Del Usuario página 5

Keep the unit in standby while setting it up ( D on page 6).
1 Cushions are attached to the tonearm
for use during transportation. Remove
them in the directions of the arrows.
Cushion for
transportation
Cushion for
transportation
2 Place the unit on a at surface.
Place it on a flat surface so that the record can be accu-
rately traced.
3 Install the turntable (platter).
Align the turntable (platter) with the center shaft and
install it.
o Place the large side of the hole down.
Center shaft
Turntable (platter)
4 Loop the belt around the motor pulley.
Loop the included flat belt around the outside of the
turntable (platter), and then loop the belt around the
motor pulley.
o Be careful not to let the rubber become twisted.
o Rotate the turntable (platter) several times to make
sure that the flat belt is secure.
4
Preparing the record player
Motor pulley
Flat belt
5 Install the pulley cover.
Align the small cutout in the pulley cover with the small
protuberance on the pulley, as shown in the illustration
below. If these are not aligned, the pulley cover will slant.
Pulley cover
6 Install the counterweight.
Place the counterweight over the end of the tonearm,
and press it gently as you turn it right to attach it.
o When the counterweight can be moved toward the
bearing, installation is complete.
Counterweight
7 Install the headshell.
Insert the headshell on the end of the tonearm and turn
the nut to secure it in place.
Nut
Headshell
Confirming levelness and fine-tuning
In order to confirm the level placement of the turntable, we
recommend using, for example, a commercially-available turn-
table leveling device. If the turntable is not level, follow the
procedures below to adjust the heights of the feet to level the
unit.
o If the slant is too great, the following method might not be
able to correct it.
1 Turn the foot on the low side counter-
clockwise to remove it.
2 Attach one of the included washers.
Washer
Foot
3 Reattach the foot in its original position.
4 Press down on the four corners of the
unit to confirm that the weight is dis-
tributed evenly on the four feet.
If one of the feet is wobbly, attach a washer to it as
explained above and adjust its height.
Balancing the tonearm and adjusting the
tracking force
Counterweight
Tracking force adjustment ring
Center line
Anti-skating dial
1 Press the STANDBY/ON button on the
back of the unit to turn it on.
The tonearm lifter will not function if the power is STANDBY.