Fig-1
Setup: Assemble
1) Extend the bottom legs on stand (I) and twist knob (I-1) to lock in
place.
2) Twist handles on stand. Fully extend both sections, adjusting for
preferred height, and tighten handles. NOTE: Leave a minimum of 8
inches extended at the top for device holder (D).
3) Unscrew washer (I-2) from top of stand. Slide studio holder (H) onto
stand with hook pointed upward and twist knob to lock in place. Screw
washer back onto top of stand.
4) Screw boom arm (G) onto top of stand.
5) Screw mic holder (F) onto end of boom arm (G).
6) Snap device holder (D) onto stand (I).
7) Holding the unlock button on back of studio, snap studio (A) to studio
holder (H) until a click is heard which means the studio is locked. Lift
up on the studio to make sure it is securely in place.