Publicidad
Idiomas disponibles
Idiomas disponibles
Connect the Handset to the Telephone
See also overview on page 2.
1. Insert the plug on the long end of the handset cable
into the jack
the cable into the groove provided.
2. Insert the plug on the short end of the handset cable
into the jack on the handset
Installation of the telephone
See also overview on page 2.
Desk Installation
By mounting the stands on the telephone using the long or
short end you can select between 22,5° and 45° tilt angle:
long end: 22,5°
1. Place the phone upside down on a soft surface and
remove all cables from the phone except the handset
cord
.
2. Insert the stands on the base of the telephone as shown.
3. Slide the stands until it locks into place
4. If your LAN does not have PoE (Power over Ethernet; ask
your administrator), then you need to use a power supply
connected to the power jack
5. Connect the LAN cable with the jack
the telephone and the wall jack.
Optional Connections
If desired, you can connect further devices to your phone (see
also overview on page 2):
Connection to PC
C
F
Connection to Headset
Connection to Key Module
D
If further settings are required for correct operation of the tele-
phone, please contact your administrator.
12
on the base of the telephone and press
G
.
short end: 45°
.
E
on the base of
C
Publicidad
