Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
LINE-IN
FOR A AND B CHANNEL
1.
Connect any unit with audio output through the appropriate 3.5mm jack cable to the LINE IN (1) input of channel
A or channel B;
2. Switch the appliance on and move the FADER balance control (22) to the channel to be used;
3. Press the LINE key (3) on the unit or the LINE key (28) on the remote control;
4. Adjust the external device from your commands.
USING THE WIRED MICROPHONE
1. Connect the supplied microphone with cable to the MIC1 or MIC2 socket
2. Turn on the microphone;
3. Adjust the microphone input volume using the Volume control (7) on the unit and adjust the ECHO using the
command (12).
TROUBLESHOOTING
If a problem occurs, follow the steps in the table below.
If the problem still can't be solved, please contact your retailer.
Problem
No response from the unit
No sound when power is
turned ON
Distorted sound
No sound from the mi-
crophone
No sound comes after
inserting USB
Remote control does not
work
Possible cause
Power cable disconnected or not connected
properly
1. No input sound source comes
2. Volume knob in the lowest position
3. USB not plugged
1. Volume is too loud
2. Audio file error
1. Microphone socket may not be plugged
properly.
2. Microphone switch may not be on.
3. Microphone volume is on lowest mode.
1. Incorrect file format
2. USB may not be plugged properly
1. The source has not been selected.
2. The remote control is very far from the
unit.
3. The batteries have not been inserted
correctly.
4. Low batteries.
5. The remote control receiver on the unit
is covered or unable to receive the
signal properly.
(16);
Disconnect and reconnect the AC power plug, then
turn on the unit again
1. Input AUX signal
2. Adjust volume
3. Plug USB,play MP3
1. Turn the volume down
2. Check and change the audio file
1. Ensure the microphone is correctly plugged
into the socket.
2. Turn on the microphone
3. Adjust the microphone volume
1. File format should be MP3
2. Plug USB correctly
1. Before you press any function button, first
select the correct source with the remote
control instead of the main unit.
2. Reduce the distance between the remote
control and the unit.
3. Insert the batteries with their polarities
(+/– signs) aligned as indicated.
4. Replace the batteries.
5. Aim the remote control directly at the
sensor on the front of the main unit.
16
XF 4500 DJ
Solution
Publicidad
