Rear Pane - Phonic PCX3000 Manual Del Usuario

1 2
4. Low Output Control
This controls the level of the low-band output between -6 and
+6 dB.
5. Low Phase Invert Control
This button reverses the phasing of the low-band output, making
the signal appropriate for out-of-phase or incorrectly wired
speakers.
6. Low Mute Button
Pushing this button will mute the low-band signal.
7. High Output Control
This controls the level of the high-band output between -6 and
+6 dB.
8. High Phase Invert Button
This button reverses the phasing of the high-band output, making
the signal appropriate for out-of-phase or incorrectly wired
speakers.
9. High Mute Button
Pushing this button will mute the high-band signal.
10. Subwoofer Crossover
Frequency Control This control will determine the crossover
frequency between the low and subwoofer frequency signals
between 10 and 215 Hz.
11. Subwoofer Gain Control
This control is used to set the output level of the subwoofer
output.
12. Subwoofer Phase Invert Button
This button reverses the phasing of the subwoofer output, making
the signal appropriate for out-of-phase or incorrectly wired
speakers.
13. Subwoofer Mute Button
Pushing this button will mute the subwoofer signal.
PCX3000
3 4
14 15
5 8
6 7 9
Rear Panel
14. AC Connector and Fuse Holder
This connector is used to supply power to the PCX3000 through
the AC cable provided along with this unit. The fuse holder located
below this connector is used to house the connector's fuse. If for
some reason the fuse blows, replace it with a fuse of identical
type and rating.
15. High Output Connectors
This connector will output the high-band signal.
16. Low Output Connectors
This connector will output the low-band signal.
17. Crossover Frequency Button
Pushing this button will raise the control range of frequencies
adjustable by the high/low crossover frequency control by 10
times (ie. when the button is released, the control range will be
between 44 and 930 Hz; pushed-in, the range will be between
440 Hz and 9.3 kHz).
18. Input Connector
Users can connect their balanced or unbalanced input signals
here.
19. Mode Button
This button determines the operating of the crossover. For 2-way
stereo operation, the button should be pressed. Release, the
PCX3000 will be set to 3-way mono.
Note: Be sure to turn your system off before changing the setting of this
button as it produces interference that may have a
negative effect on speakers or other equipment.
20. Subwoofer Output Connectors
This connector will output the subwoofer signal. This signal
remains constant when in mono or stereo mode.
16 17 18
12
10 11 13
19 20
5