Cameo PIXBAR Serie Manual De Usuario página 27

INSTALLATION
DANGEROverhead mounting requires extensive experience, including the calculation
of the load limit values of the installation material and regular safety inspection of all
installation materials and spotlights. If you do not have these qualifications, do not
attempt to perform an installation yourself. Refer instead to a qualified professional.
There is a risk that devices that are incorrectly mounted and secured may come
loose and fall down. This can cause serious injury or death.
The unique coupling mechanism means that when several PIXBAR® G2 are docked, there is also
a uniform pixel spacing at the transitions from one to the next PIXBAR® G2.
Thanks to the adjustable stand or mounting feet, the PIXBAR® G2 can be set up in a suitable
position on a flat floor (e.g. as an uplight).
MOUNTING A PIXBAR® ON A TRUSS
Mounting on a truss is done using optionally available truss clamps, which are either attached
directly to the mounting feet (1), or to optionally available Omega mounting brackets (part number
CLOMEGABRACKET1). The mounting feet can be moved on the housing of the PIXBAR® G2. To do
this, loosen the middle of the five hexagon socket screws (2), move the foot to the desired position
and tighten the screw again. The direction of radiation can be adjusted using the tommy screws
(3) on the mounting feet. Ensure that the connections are tight and that the PIXBAR® G2 cannot
come loose. When mounting the PIXBAR® G2 overhead, secure it with a suitable safety rope to
one of the safety lugs provided (4). When mounting several docked PIXBAR® G2 horizontally over-
head, each individual PIXBAR® G2 must be attached separately to the truss with the mounting
feet and secured with a suitable safety rope.
1
3
2
4
1
4 3
2
27