Velleman EAGLE EYES CAMIP13 Guía Rápida página 6

1. On your mobile device, switch your network mode to 3G or connect to a different wireless network
than the one that has your camera connected.
2. Start EagleEyes and select the camera you just added to see if you can access it.
If yes, your network connection works. Proceed with Changing the account user name and
o
password below.
If not, proceed with the next step.
o
3. Switch your network mode back to the wireless network that has your camera connected.
4. Start EagleEyes, and add a new connection with the IP address and port number that you set up in
Adding your camera to the EagleEyes app.
5. See if you can access the camera with this connection.
If yes, return to Port Forwarding to set up port forwarding again.
o
If not, return to step 4 of Adding your camera to the EagleEyes app and reconfigure the
o
connection.
f. Changing the account user name and password in EagleEyes
To ensure the safety of your camera connection, modify the default user name and password as follows:
1. On your mobile device, access the camera in EagleEyes.
2. Press the Configuration button
3. Select Advance Setup > Account.
4. Modify the default user name (admin) and password (admin) to the ones you prefer.
g. Activating Push Video
Push Video is an active notification system. If it is enabled, you will receive event notifications on your
mobile device within 5 seconds.
Note: Push Video will only be triggered through the Alarm in. Refer to Installation: cable connections
above for details.
Proceed as follows to enable Push Video:
1. On your mobile device, open EagleEyes.
2. In the Address Book, switch the button next to your camera to "ON". The device shows a message
that Push Notification (Push Video) is enabled. Press "Close" to return to the Address Book.
3. When the camera detects an event, it will record a video clip and send a notification to your mobile
device.
4. Start Eagleeyes and select "View" to play the recorded clip.
V. 01 – 22/03/2012
CAMIP13
.
6 ©Velleman nv