If too much paper is inserted in the cutting unit, it will cause a jam.
Proceed as follows:
- Push the sliding switch to the Paper REV position.
- The cutting unit runs backwards and pushes the excess paper back.
- Reduce the quantity and slide the switch to AUTO again. The cutting unit runs forward
again and the residue remaining is shredded.
If the backwards and forwards movement does not remedy the jam, pull out the mains
plug and remove the remaining manually from the cutting unit.
Warning:
If the above method does not work with the jammed shredder, switch the shredder off
and take it back to the dealer for repair.
1.
If you want to empty the waste bin, please make sure the unit is switched off and the
power cord is unplugged
2.
Remove the shredder head and empty the waste paper bin and the small CD bin.
3.
Replace back the shredder head on the waste bin correctly.
Warning:
Paper clogs the shredder head if the waste bin is too full. Always empty the waste bin
when the bin is full.
The motor switches off automatically in the event of overloading. Pull out the mains plug
from the socket and allow the motor to cool down to room temperature. Plug the mains
cable back in and then continue operation.
Caution:
Maintenance work may only be performed when the mains plug is pulled out.
Clean the housing with a slightly moist cloth.
Do not use any aggressive cleaning agents. Never use any chemicals (e.g. cleaning
solvent, alcohol) to clean the housing.
To ensure your shredder enjoys a long working life, we recommend to clear residual ma-
terial from the cutting units at regular intervals and apply special oil for paper shred-
ders to the cutting unit. You can purchase a special CFC-free oil from your specialist
retailer or directly from our Service Center in Hattingen. This will extend the service life
of the device.
Attention: It is forbidden to use oil spray bottles containing CFC!
Model:
Power supply:
Cutting width of the paper slot:
Cutting width of the CD slot:
BDA_PS_28.indd 12
Clearing a jam
Emptying the waste bin
Motor protection
Notes on care and maintenance
Technical data
PS 28 CCD
240 V/50 Hz
220 mm
122 mm
12
22.03.2011 9:02:00 Uhr