Descargar Imprimir esta página

Danby Designer DCF096A2WDD Guía De Utilización Y Cuidado Para El Propietario página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

Operating Instructions
VACATION
For short vacation periods, leave the unit at its regular setting. During longer absences:
1. Remove all foods.
2. Disconnect the power cord from the electrical outlet.
3. Defrost and clean the freezer thoroughly.
4. Leave the lid open to avoid possible formations of condensation, mold or odors.
MOVING
Remove or securely fasten down all loose items inside the unit. To avoid damaging the levelling legs,
turn them all the way into the base.
If it is necessary to transport the unit on its back or side, ensure that the unit is allowed to remain up-
right and undisturbed for a minimum of 4 hours to allow the coolant to settle.
Troubleshooting
PROBLEM
Does not work •
Freezer runs
continuously
Internal tem-
perature not
cold enough
All manuals and user guides at all-guides.com
POSSIBLE CAUSE
No power to unit
Power cord is unplugged
Wrong voltage is being used
Temperature set too low (too
cold)
Lid is not closed
Hot food was inserted
Lid opened too long or too often
Close proximity to heat source
or direct sunlight
No power to unit
Power cord is unplugged
Temperature set too high
Lid is not closed
Hot food was inserted
Lid opened too long or too often
Air fl ow obstruction
Wrong voltage is being used.
Close proximity to heat source
or direct sunlight
Tel: 1-800-26-DANBY (1-800-263-2629)
Check connection of power cord to power
source
Plug in unit
Use proper voltage
Set temperature control to warmer setting
Close lid securely
Be sure food is at room temperature be-
fore inserting
Minimize lid openings / duration
Do not place unit close to heat sources or
direct sunlight
Check connection of power cord to power
source
Plug in unit
Check setting and increase as needed
Close lid securely
Be sure that food is at room temperature
Minimize lid openings / duration
Allow room for air to circulate around unit
Use proper voltage
Do not place unit close to heat sources or
direct sunlight
5
SOLUTION

Publicidad

loading