Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
STEP 4 Connect the water hose
The dryer must be connected to a cold water tap using the provided water hoses.
If the Y connector cannot be directly connected to the cold water tap, use the short hose
as shown on the following page.
22
English
DV7750M-03170Y-01_EN.indd 22
All manuals and user guides at all-guides.com
1. Close the cold water tap. If you have a
washer cold water hose attached to the
cold water faucet, unscrew and remove
the hose. Then, connect the female end
of the Y connector to the cold water
tap.
2. Connect the straight end of the water
hose to the Y connector.
3. Using pliers, tighten the coupling an
additional two-thirds turn. Do not
overtighten because the coupling may
be damaged.
4. Connect the angled end of the water
hose to the filling valve at the bottom
of the rear frame. Turn the coupling
manually until it is tight.
5. Using pliers, tighten the coupling an
additional two-thirds turn. Do not
overtighten because the coupling may
be damaged.
6. If you detached the cold water hose
from your washer, attach the hose
to the open end of the Y connector,
tighten the coupling until it is tight,
and then, using a pliers, tighten an
additional two-thirds turn.
7. Open the cold water tap, and then check
for any leaks.
2017-03-15
11:49:34
Publicidad
