HERKULES 43.406.41 Manual De Instrucciones página 23

Anleitung TK 1800 UV_SPK7
9.1.2. Cutting narrow workpieces (Fig. 24)
Be sure to use a push stick (3) when making
longitudinal cuts in workpieces smaller than 120
mm in width. A push block is supplied with the
saw!
Replace a worn or damaged push stick
immediately.
9.1.3. Cutting extremely narrow workpieces (Fig.
25)
Be sure to use a push block when making
longitudinal cuts in very narrow workpieces with
a width of 30 mm and less.
The low guide face of the parallel stop is best
used in this case.
There is no push block supplied with the
saw! (Available from your specialist dealer)
Replace the push block without delay when it
becomes worn.
9.1.4. Making concealed cuts (Fig. 26)
Concealed cuts and groove cuts are possible thanks
to the removable blade guard and the infinitely
adjustable cutting height.
Remove the blade guard (2) (see 7.3).
Set the splitter (5) for concealed cuts (see 7.4.2.)
Set the desired cutting depth (Fig. 8.2)
Mount the parallel stop (7) to the right of the
blade and set the desired width (8.3.2)
Push the workpiece into the blade (4). Make
sure that the workpiece lies solidly on the saw
table (1).
Select the cutting sequence so that the cut strips
fall away on the left side of the blade and
jamming between the stop and the blade is
prevented (risk of kick-back).
After you have finished cutting, refit the blade
guard (2) immediately.
9.1.5. Making bevel cuts (Fig. 16/27)
Bevel cuts must always be used using the parallel
stop (7).
Set the blade (4) to the desired angle. (See 8.5.)
Set the parallel stop (7) in accordance with the
workpiece width and height (see 8.3.1)
Carry out the cut in accordance with the
workpiece width (see 9.1.1., 9.1.2 and 9.1.3.)
9.1.6. Making cross cuts (Fig. 28)
Slide the cross stop (14) into one of the grooves
(49) in the table and adjust to the required angle.
(See 8.4.) If you also want to tilt the blade (4),
use the groove (49) which prevents your hand
and the cross stop from making contact with the
blade guard.
If necessary, use the stop rail (25).
13.10.2006 8:19 Uhr Seite 23
Press the workpiece firmly against the cross stop
(14).
Switch on the saw.
Push the cross stop (14) and the workpiece
toward the blade in order to make the cut.
Important:
Always hold the guided part of the
workpiece. Never hold the part which is to be
cut off.
Push the cross stop (14) forward until the
workpiece is cut all the way through.
Switch off the saw again. Do not remove the
offcut until the blade has stopped rotating.
10.0. Maintenance
Important! Pull out the power plug first.
Remove dust and dirt regularly from the
machine. Cleaning is best carried out with a fine
brush or a cloth.
Never use caustic agents to clean plastic parts.
11.0. Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
GB
23