Denver TC-19C Manual De Instrucciones página 3

PROGRAMMING THE CD PLAYER
Programming is the ability to preselect the order in which a series of tracks will be played.
1. Lift up the CD door to open the CD compartment. Place a disc on the
spindle, label side up, and close the CD compartment door.
2. Set the FUNCTION Selector switch to the CD position. The total number of tracks will appear on
the display
3. Press the PROGRAM button. A program number & PROGRAM indicator will blink on the display.
4. Use the of Button to display the first track of your selected program Then press
the PROGRAM button; the selected track has now been programmed and counted as program 1.
5. Repeat step 4 to program the order desired tracks in sequence.
6. Programming is limited to a maximum of 20 tracks. Each track may be stored in program
memory as many times as desire.
7. The whole program memory can be cleared by opening the CD compartment or changing the
position of the FUNCTION selector switch.
8. Once you have finished programmed press the PLAY/PAUSE button. The PROGRAM indicator will
light and the tracks will play in the order programmed. As each track is played, its track number will
be displayed You can move forward or backward through the programmed tracks will the
buttons. The CD player will stop after all programmed tracks have been played.
RADIO OPERATION
ANTENNAS
FM- The telescopic antenna on the top of the unit is for FM reception only. If reception
is weak, adjust the length and the angle of the antenna.
TO LISTEN TO A RADIO STATION
1. Set FUNCTION selector to FM position.
2. Tune a desired station by tuning the TUNING KNOB (Fig A).
3. Adjust VOLUME control (16) to suit your personal listening preference.
4. To switch the radio off, set the FUNCTION SELECTOR (15) to AUX position.
FM CD STEREO
AUX IN
You can connect any auxiliary device like music player to this unit.
1. Connect the device to the AUX IN jack (cable not provided).
2. Setting the FUNCTION (15) switch to AUX position.
3. Adjust the volume of your device if needed.
SPECIFICATION
GENERAL
Power requirement AC 230V~ 50Hz
Dimension unit 264 mm (W) x 174 mm (D) x 90mm (L)
RECEIVER SECTION
Receiving bands FM
Tuning range / Sensitivity
FM 88 - 108 MHz
CD PLAYER SECTION
Playback system 3 - beam laser pick-up
Frequency response 100 - 18000Hz
AUDIO SECTION
Power output 0.8 Watts X 2
or
Fig A
EN-4
Electric and electronic equipment contains materials, components and
substances that can be hazardous to your health and the environment,
if the waste material (discarded electric and electronic equipment) is
not handled correctly.
Electric and electronic equipment is marked with the crossed out trash
can symbol, seen below. This symbol signifies that electric and
electronic equipment should not be disposed of with other household
waste, but should be disposed of separately.
All cities have established collection points, where electric and
electronic equipment can either be submitted free of charge at
recycling stations and other collection sites, or be collected from the
households. Additional information is available at the technical
department of your city.
EN-5