Descargar Imprimir esta página

Publicidad

Enlaces rápidos

FEATURES
High power 550 lumen white COB LED, 6500k
Additional 450 lumen 6500K Cree LED spot beam LED
Super tough polycarbonate construction
125° Rotational head
Memory switch - remembers last mode used
Adjustable non-slip silicone lined headband
IP65 dust & water resistant
IK07 super tough construction - 2m drop proof
High quality 3.7v 1500mAh Li-po battery
Built-in USB-C charging port with protective cover
Green Flash-to-Green charging indicator
Low battery 3x warning flash - reminds when charging is needed
2A USB-C charging - fast 3 hour charge time
1m USB-C charging cable included
Can be wireless charged using Unilite's WCSGL or WCDBL
wireless charging pads
BATTERY - 3.7v 1500mAh Li-po Rechargeable Battery
WEIGHT - 104g
DIMENSIONS - 70 x 52 x 46mm
ADVICE & IMPORTANT INFORMATION!
LEDs will become warm/hot when switched on; do not touch and never place LEDs face
down on any surface – risk of fire!
Do not look directly at the LED. Do not operate in direct sunlight or extreme temperature
conditions (below -10°C or above 40°C).
Do not use the device if there is any visible damage to the housing, charge port, switch or
cable. Take care when using a USB plug adaptor, check for any damage. DO NOT exceed
the stated charging inputs or damage may occur to the internal battery and may void the
warranty.
The rechargeable battery will reach full performance after a few complete charging and
discharging cycles. Fully charge before first use.
To keep the rechargeable battery in optimum condition, it should be recharged every
3-6 months, especially if it is not being used for a long period of time. Always fully charge
batteries before storage.
Always protect lithium batteries from heat, intense sunlight, fire, water and moisture –
danger of explosion!
If a battery is damaged, fluids can leak out. AVOID contact as this can lead to skin irritation
and/or burns. If skin contact occurs, rinse thoroughly with water. If irritation persists, seek
medical advice. Seek immediate medical assistance if lithium battery fluid comes into
contact with the eyes.
Children under 12 years of age should only use the product under adult supervision.
Do not open, disassemble or attempt to modify the product; this will void the warranty and
can be dangerous. Improper use or modification is not covered under the warranty.
Take care not to let the lenses come into contact with hard/sharp objects, damage/scratches
to the lenses will affect light output.
This product is water resistant to IPX5 - DO NOT SUBMERGE. If the product has been
subjected to excessive water the warranty may be void.
This product has a 1 year standard warranty (or extended to 2 years once registered online
at WWW.UNILITE.CO.UK/WARRANTY) against manufacturing faults and defects. It does not
cover normal wear and tear, modifications, accidental damage or poor maintenance. Unilite
warranties do not cover disposable battery leakage or the use of incorrect chargers and
cables that can damage rechargeable batteries.
Do not dispose of this device in normal household waste. It must be disposed of via an
authorised electrical appliance disposal centre or at your local waste disposal unit.
Please re-use or recycle packaging where possible.
Keep these instructions for future reference or for subsequent possessors.
www.unilite.co.uk
ANSI FL 1 Standard
Spot Beam
Floodlight - Low
Floodlight - Mid
Floodlight - High
OPERATION
TOP SWITCH Sequence:- Spot Beam > Floodlight Low > Floodlight
Medium > Floodlight High > Off
MEMORY FUNCTION:- If left ON in any mode for 5 seconds or more,
the next press will turn OFF. Next press ON will return to that last mode
used.
On/Off
Switch
Spot Beam
LED
COB LED
Charge
Port
CHARGING
Option 1 - Direct Charging:
• Only use a 5V USB-C cable (max 2A).
• Lift the charge-port cover on the bottom of the headtorch and plug
the USB-C end of the cable into the port.
• Plug the USB-A end of the cable into a USB charging port (do not
exceed 5V 2A charging input or damage may occur).
• A green LED on the front of the headtorch will flash to indicate
charging. The LED will light up solid green to confirm fully charged.
• Charge Time: 3 hours
Option 2 - Wireless Charging:
• Only use Unilite's WCSGL single or WCDBL double wireless charging
pads.
• Plug the USB-C end of the cable into the charge port on the bottom
of the charging pad.
• Plug the USB-A end of the cable into a USB charging port (ensure
you pay attention to the max charging inputs on the back of the pad).
• Then place the light onto one of the wireless charging pads taking
note of the magnetic connections.
• The green LED on the front of the headtorch will flash to indicate
charging. The LED will light up solid green to confirm fully charged.
• Charge Time: 4 hours (based on 2A charging input)
**Warranty void if not used with the
specified cables/chargers**
WCHT5
450
84 M
Lumen
35
6 M
Lumen
275
15 M
Lumen
550
31M
Lumen
125° Rotating
Head
Wireless Charge
Connection
Strong
Magnet
Charging
Indicator
4 H
21 H
8 H
4 H

Publicidad

loading

Resumen de contenidos para UNILITE WCHT5

  • Página 1 This product has a 1 year standard warranty (or extended to 2 years once registered online at WWW.UNILITE.CO.UK/WARRANTY) against manufacturing faults and defects. It does not cover normal wear and tear, modifications, accidental damage or poor maintenance. Unilite warranties do not cover disposable battery leakage or the use of incorrect chargers and cables that can damage rechargeable batteries.
  • Página 2 ON ritornerà all’ultima modalità utilizzata. del sole o in condizioni di temperatura estreme (inferiore a -10°C Le garanzie Unilite non coprono le perdite di batterie usa e getta o o superiore a 40°C). l’uso di caricabatterie e cavi non corretti che possono danneggiare...
  • Página 3 INSTRUCCIONES DE OPERACIÓN Los LED se calentarán / calentarán cuando se enciendan; No toque extiende a 2 años una vez registrado en línea en WWW.UNILITE. Secuencia TOP SWITCH: - Haz puntual> Floodlight Low> Floodlight y nunca coloque los LED boca abajo sobre ninguna superficie - CO.UK/WARRANTY) contra fallas y defectos de fabricación.