MoMi LEXI XL Manual De Usuario página 6

• The guardrail does not ensure safety corresponding to the one offered by a cot or playpen.
• The guardrail should always be used with mattresses sized:
- bed length greater than 200 cm
- minimum thickness 3 cm, maximum thickness 25 cm
• Do not use the guardrail if the mattress top is situated higher than 60 cm above the fl oor.
• Never use the guardrail with a bunk bed, camp bed, cot or other bed not conforming to the user
manual.
• To avoid injuries, read the assembly, installation and user manual carefully.
• Check, on a regular basis, if the guardrail is installed correctly and its locking mechanisms are
locked.
• Protect the guardrail from the sources of fi re and heat.
• Install the guardrail to ensure that its side touches the mattress side when it is locked or installed.
• The guardrail may only be used after its fasteners have been secured and attached safely both to
the bed or mattress and to the guardrail.
• The installed guardrail should be checked for its correct installation and securing.
• If you need any spare parts, contact the manufacturer. Do not use spare parts not provided by the
manufacturer.
• WARNING – To avoid the risk of strangulation, after the guardrail is installed ensure that at least 250
mm of space is left between every bed end and the guardrail end.
• The guardrail must adjoin the mattress edge closely and all fasteners must be installed correctly.
• The upper guardrail edge must be at least 16 cm above the mattress top.
COMPONENTS:
A1. Nylon mesh
B1. Joint pipe on top left corner
B2. Joint pipe on top right corner
C1. Joint pipe on left bottom
C2. Joint pipe on right bottom
PRODUCT ASSEMBLY:
1. Assemble top joint pipes (B1 and B2).
2. Pass the top joint pipeline through the nylon mesh (A).
3. Connect the interface on both sides with the legs (D1 and D2).
4. Pull down the nylon mesh (A).
5. Assemble the bottom joint pipes (C1 and C2). Pass the bottom joint pipe through the bottom of the
nylon mesh (A) and connect it with the legs (D1 and D2).
6
D1. Left leg
D2. Right leg
E. Plastic leg fi xing
F. Screws
G. Mounting belt
EN