Bosch 0.601.944.703 Manual Original página 15

OBJ_BUCH-485-002.book Page 14 Wednesday, November 26, 2008 1:56 PM
14 | English
Safety Notes
en
Read all safety warnings and all
instructions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or
serious injury.
Be careful when working with the power
tool. The power tool produces intense heat
which can lead to increased danger of fire
and explosion.
Exercise special care when working close to
inflammable materials. The hot air jet or the
hot nozzle can ignite dust or gases.
Do not operate or work with the power tool
in areas where there is danger of explosion.
Never direct the hot air jet at the same po-
sition for longer periods. Easily inflammable
gases can develop e.g., when working plas-
tic, paint, varnish or similar materials.
Be aware that heat can be conducted to hid-
den covered materials and can ignite them.
After using, place the power tool down in a
secure manner and allow it to cool down
completely before packing it away. The hot
nozzle can cause damage.
Do not leave the switched-on power tool un-
attended.
Store idle power tools out of the reach of
children. Do not allow persons unfamiliar
with the power tool or these instructions to
operate the power tool. Power tools are
dangerous in the hands of untrained users.
Do not expose the power tool to rain or wet
conditions. Water entering a power tool will
increase the risk of electric shock.
Do not abuse the cord. Never use the cord
for carrying, pulling or unplugging the
power tool. Keep cord away from heat, oil,
sharp edges or moving parts. Damaged or
entangled cords increase the risk of electric
shock.
Always wear safety goggles. Safety goggles
will reduce the risk of injuries.
1 609 929 S53 | (26.11.08)
Disconnect the plug from the socket outlet
before making any adjustments, changing
accessories, or placing the power tool
aside. This safety measure prevents uninten-
tional starting of the power tool.
Check the power tool, cord and plug each
time before use. Do not use the power tool
if damage is determined. Do not open the
power tool yourself and have it serviced
only by a qualified repair person using only
original spare parts. Damaged power tools,
cords and plugs increase the risk of electric
shock.
Provide for good ventilation of
your working place. Gas and va-
pour developing during working
are often harmful to one's health.
Wear safety gloves and do not touch the hot
nozzle. Danger of burning.
Never direct the hot air jet against persons
or animals.
Do not use the power tool as a hairdryer.
The hot air being blown out is significantly
hotter than that from a hairdryer.
When operating the power tool in damp
environments is unavoidable, use a residual
current device (RCD). The use of a residual
current device (RCD) reduces the risk of an
electric shock.
Products sold in GB only: Your product is
fitted with an approved 13 A (BS 1363/A)
electric plug and is protected by a 13 A fuse
(ASTA Approved to BS 1362).
If the plug is not suitable for your socket out-
lets, it should be cut off and an appropriate
plug fitted in its place by an authorised
customer service agent.
The severed plug must be disposed of to
avoid a possible shock hazard and should
never be inserted into a 13 A socket else-
where.
Bosch Power Tools