Aqua Marina BLUEDRIVE X Guia Del Usuario

BLUEDRIVE X Repeater User Guide
EN
USE SCENARIO
This BLUEDRIVE X repeater is compulsory for use in sea or salt water.
HOW-TO USE
The repeater can be charged and stored in the same way as the remote control (RC-23BX).
Successfully pair the repeater before use. How to pair your device:
Caution!
Before pairing ensure the following：
· The remote is already paired with the device (refer to page 15 of your user manual).
· The battery is already installed on the device and the remote control is turned on.
PF-240X Pairing Method：
Position the repeater, remote control, and device within a maximum distance of 50cm from each other. Locate the
power button on the repeater and press it to turn it on. The repeater will initiate the automatic pairing process. Wait
for pairing to complete, indicated by the repeater's indicator light flashing orange for approximately 2 seconds. If
unsuccessful, the repeater's indicator light will remain constantly lit.
PF-240XP Pairing Method：
Position the repeater, remote control, and device within a maximum distance of 50cm from each other. Press and
hold the power button on the repeater for approximately 3 seconds to turn it on. The repeater will initiate the
automatic pairing process. Wait for pairing to complete, indicated by the repeater's indicator light flashing green. If
unsuccessful, the repeater's indicator light will remain constantly lit.
*If there are other Aqua Marina products within a 20-meter range, it may cause pairing failure. If the pairing is still
unsuccessful after 60 seconds, turn off the repeater, move away from other working Aqua Marina products, and try
the pairing process again.
PLACEMENT
After pairing, secure the repeater with the watch band in the recommended position suggested by the
diagram below.
SUP/KAYAK MODE:
Secure within a radius of 30cm-60cm from the fin box, such as the SUP board leash D-ring, a kayak/
canoe's rear seat D-ring, etc.
φ=120cm
φ=60cm
Note：
* If the indicator light of the repeater rapidly flashes during operation, it indicates a weak signal between the repeater and the main
unit, potentially affecting the accuracy of the main unit's power indication. To resolve this, please position the repeater near the
device and wait for the indicator light to resume a slow flashing pattern.
* Once the device and the repeater are paired, it is recommended to keep the repeater operational throughout the entire usage
process, until the battery is reinstalled.
φ=60cm: Strong Signal Range
φ=120cm: Maximum Signal Range
HANDHELD MODE:
Place anywhere on the same side of the
bracket as the remote control.
φ=120cm
φ=60cm
Note: In SUP/kayak mode, ensure that the repeater is
secured above water within the maximum signal range.
MODEL: RE-23BX