Operation - Metabo HPT UU 240R Instrucciones De Seguridad E Manual De Instrucciones

OPERATION INSTRUCTIONS
WARNING
Take care during setting up and folding the stand to
reduce the hazard of pinching hands and fingers.
SETTING UP THE STAND (FIG. S)
1. Lift the stand to its upright position.
2. Unfold the stand by stepping on the foot pedal (1)
to release the locking treadle hook, and press down
on stand handles (2) until the stand is in its lowest
position.
NOTE: You should hear a click when locked in place.
WARNING
● Do not mount the miter saw unless the stand top is
securely locked.
● To reduce the risk of pinching hands and fingers,
be aware of doing every operation while raising or
lowering the stand.
● To prevent injury, be sure to grab the stand handles
BY BOTH HANDS while raising or lowering the
stand.
Fig. S
1
2
Upright position
FOLDING THE STAND (FIG. T)
1. Hold the stand handles with BOTH HANDS and
press two stand locking levers (3) to release the
locking treadle hook.
2. Slowly lift the stand handles up until you hear a
click from the foot pedal (1) locked in place so that
the stand is folded in its upright position as shown
in Fig. T.

OPERATION

Lowest position
– 15 –
WARNING
● Before folding the stand, remove the miter saw from
the stand together with the mounting brackets by two
or more people.
● Be sure to hear a click when locked in place before
you move the stand.
● If the stand cannot be locked, check the installation
of the bumper and re-install it. If the lock is still not
working, please contact a metabo HPT authorized
service center.
Fig. T
Upright position
English
3
1