PRESIDENT JOHNSON II Manual Del Usuario página 33

a) press MEM during the scanning cycle of the channels. «MEM» is displayed. The
transceiver scans the active memories (M1, M2, M3) and channels 19 and 9.
b) press SCAN during the recall cycle MEM of the memories. «SCAN» is displayed. The
transceiver scans the active memories (M1, M2, M3) and channels 19 and 9.
M2
(see § 9)
8) AM/FM ~ LOCAL ~ M1
AM/FM
(short push)
This switch allows to select the modulation mode AM or FM.
Your modulation mode must correspond with the one of the person you are
speaking to.
AM/ Amplitude Modulation (AM) is for communications in areas where there
are obstacles and over medium distances.
FM/ Frequency Modulation (FM) is for nearby communications in flat, open
areas.
AM/FM
2 nd function (only in U configuration)
Allows to alternate the frequency bands CEPT and ENG in the U configuration.
When the ENG frequency band is selected, «UK» is displayed.
LOCAL
(long push)
Allows the automatic adjustment of the RF Gain for close communication.
«LOCAL» is displayed.
M1
(see § 9)
9) MEM ~ F
MEM
3 channels can be memorized with following parameters: AM (except for EC
and U configurations) or FM; LOCAL; NB/ANL; HICUT (and CEPT/ENG in the U
configuration)
To memorize:
- press shortly on MEM, «MEM» blinks.
- Press during 1 s on M1, M2 or M3. «MEM» is displayed continuously. The
channel has been memorized.
To recall a memory:
- press shortly on MEM, «MEM» blinks.
- press shortly on M1, M2 or M3.
- «MEM» is displayed continuously. The memorized channel is active.
To delete a memory:
- turn off the transceiver.
- keep key M1, M2 or M3 pressed and switch on the transceiver.
- the selected memory is deleted.
F - FREQUENCY BAND SELECTION
(configuration: E; d; EU; EC; U; PL)
The frequency bands must be chosen according to the country where you are
going to operate. Do not use another configuration. Some countries require
user's licence. See the table on page 51.
How to proceed:
- switch off the transceiver
- press and hold the F key and switch on the transceiver. «F» blinks and the letter
corresponding to the configuration blinks.
- In order to change the configuration, use the / keys on the front panel
or UP and DN on the microphone.
- When the configuration is selected, press on the F key during 1 s. «F» and the
letter corresponding to the configuration is continuously displayed. At this
stage, confirm the selection by switching off then switching on again the
transceiver.
See table on page 50.
10) 6-PIN MICROPHONE PLUG:
This plug is situated on the front panel, thereby making it easier to set the
equipment into the dashboard. See the cabling diagram on page 49.
11) PTT (push to talk):
Press this knob to transmit a message and release to listen to an incoming
communication.
A) DC-POWER TERMINAL (13.2 V)
B) ANTENNA CONNECTOR (SO-239)
C) EXTERNAL SPEAKER JACK (8 Ω Ω Ω Ω Ω , Ø 3.5 mm)
33