Vornado EXO5-EU Manual Del Propietário página 7

ASSEMBLY
The EXO5 can be used in one of three different ways.
1. Connect the Locking Socket Joint (B) to the
EXO5 Fan Head (A) at any flat location along
the Roll Cage (C).Before proceeding, ensure
that the knob is properly tightened and the
Locking Socket Joint (B) is fully secured to the
Fan Head (A). Do not pinch the power cord
between the Locking Socket Joint (B) and the
Fan Head (A).
2. To connect the Fan Head/Locking Socket Joint
assembly to either the to the Clamp (E) or the
Tripod Base (F), simply insert into the under side
of the Locking Socket Joint (D) and twist
until secured.
3. To remove Clamp (E) or the Tripod Base (F),
simply twist until loosened.
12 English
A
C
B
D
E
F
HOW TO USE
TRIPOD BASE ATTACHMENT
1. After product assembly, position unit on flat and level surface
as shown below.
2. To adjust angle of head tilt, simply loosen the connection
between the Fan Head (A) and the Tripod Base (B) with a twist,
adjust to desired angle and then twist to retighten.
Note: Product
should be used
A
with Tripod
Base (B) in
fully extended
position and
fully secured to
Fan Head (A).
B
Note: For both attachment options, keep the electrical cord safely routed to avoid being tripped over or pulled. Avoid placing the
product where it could be easily bumped.
CLAMP ATTACHMENT
1. After product assembly, twist the Cam Lock Knob (C) to
open the Clamp (D).
2. Position the Clamp (D) over a solid surface up to 2" thick.
3. Twist the Cam Lock Knob (C) to tighten. Take care Clamp (D)
is fully engaged on solid surface before releasing.
Note: DO NOT
attach to slick or
oily surfaces as
this may allow
product to come
loose. Make sure
solid surface can
support the weight
of the product.
D
C
13
English