Descargar Imprimir esta página

Bahco BCL33AP1 Instrucciones De Funcionamiento página 8

Pulidora inalámbrica

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 34
6. Your new battery pack is not charged. You need to charge it before use.
7. If you try to charge a battery pack from a just-operated machine, sometimes the charging
light will not come on. If this occurs, let the battery pack cool for a while then re-insert it and
try to charge again.
8. When you charge a new battery pack or a battery pack which has not been used for a long
period, it may not accept a full charge. This is a normal condition and does not indicate a
problem. You can recharge the battery pack fully after discharging it completely a couple of
times.
9.    U nplug the charger from the power source after finishing the charge.
10. Please remove the battery from the unplugged charger for storage.
Fuel gauge LED display on machine
1. The machine has 3 steps green LED for indicating remaining battery capacity status by
press down trigger; LED will stay illuminated for 3 seconds. (by press down trigger if you
wanted to display battery capacity status once again).
2.    I f LED 1.is flashed by 3 times that indicates battery pack need to be recharged.
3.    O ver temperature protection: if 3 fuel gauge LED are flashing together by 3 times, it 
indicates battery is over temperature.
Fuel gauge LED indication
LED 1 (green)
LED 1, 2 (green)
LED 1, 2, 3 (green)
The LED Light on the Charger
Power On (Green light flashes slowly)
Battery Low (Red light stays illuminated)
Battery charged 80% (Green light flashes rapidly)
Battery charged 100% (Green light stays illuminated)
Battery Pack temperature is too hot or too cold (Red light flashes slowly)
Battery Pack malfunction (Red and Green lights stay illuminated)
WARNING
1. Charger is plugged into a 100-240V a.c outlet only.
2. If the battery pack is too hot or too cold, the charger will not fast charge the battery pack
and the red Indicator light is "blinking". When the battery pack temperature returns to
between 0°C (32°F) and 50°C (122°F), The charger will automatically begin charging.
3. If both red and green indicator lights are "ON" the battery pack either does not comply or is
defective. Please contact your retailer.
4. Do not charge the battery pack in the rain, snow or high temperature environment.
5. Do not charge battery pack when environment temperature is below 0°C (32°F) or above
40°C (104°F)
6. While charge the cool battery pack (below 0°C) in the warm indoor, keep the battery pack in
the room for one hour to warm up before starting the battery pack.
7.    R emove the plug after finishing the charge.
8. The charger should be cooled at least one hour after continue charging three times.
9. Do not use generator for charging the battery pack.
RC Status
0% - 33%
34% - 66%
67%-100%
8

Publicidad

loading

Este manual también es adecuado para:

Bcl33ap1k1