Códigos De Error - Intesis IntesisBox ME-AC-KNX-1i Manual De Usuario

®
KNX – Mitsubishi Electric A/A
IntesisBox
7. Códigos de error
Código Descripción
(En Hexadecimal)
-1 Communication error between the ME-AC-KNX-1i gateway and the AC unit
0 No active error
0001 Communication error with the AC unit
1102 Discharge Temperature high
1108 Internal thermostat detector working (49C)
1110 Outdoor unit fail
1300 Pressure low
1302 Pressure high (High pressure probe working 63H)
1503 Protection against freeze or battery high temperature
1504 Protection against freeze or battery high temperature
1504 Over heating protection
1509 High pressure error (ball valve closed)
1520 Super heating anomaly due to low temp. of discharge. (TH4)
2500 Erroneous operation of drain pump
2502 Erroneous operation of drain pump
2503 Drain sensor anomaly (DS)
4030 Serial transmission error
4100 Compressor pause due to excess of current (initial block)
4101 Compressor pause due to excess of current (overload)
4102 Phase detection opened
4103 Anti-phase detection
4108 Phase opened in phase L2 or connector 51CM opened
4118 Error in the anti-phase detector (electronic board)
4124 Connector 49L opened
4210 Cut due to over-current of compressor
4220 Voltage anomaly
4230 Radiator panel temperature anomaly (TH8)
5101 Ambient temperature probe anomaly (TH1), indoor unit
5102 Liquid probe anomaly (TH2)
5102 Cond/Evap probe anomaly (TH5)
5104 Error detection in discharge temperature
5105 Outdoor probe error TH3
5106 Outdoor probe errorTH7
5107 Outdoor probe errorTH6
5110 Outdoor probe errorTH8
5202 Connector 63L opened
5300 Current probe error
6600 MNET duplicated address definition
6602 MNET Line transmission hardware error
6603 MNET BUS busy
6606 MNET Line transmission error
6607 MNET transmission error
6607 MNET without ack
6608 MNET transmission error
6608 MNET without response
6831 IR remote control transmission error (reception error)
6832 IR remote control transmission error (transmission error)
6840 Transmission error with the indoor/outdoor unit (reception error)
6841 Transmission error with the indoor/outdoor unit (transmission error)
6844 Error in inter-connection cable in the indoor/outdoor unit, indoor unit number deactivated (5 min or more)
6845 Error in inter-connection cable in the indoor/outdoor unit (cabling error, disconnection)
6846 Initial timer deactivated
En caso de detectar un código de error que no aparezca en la lista, contacte el servicio
técnico Mitsubishi Electric más próximo para obtener más información acerca del significado
de dicho error.
© Intesis Software S.L. Todos los derechos reservados
La información en este documento está sujeta a cambios sin previo aviso
IntesisBox es una marca registrada de Intesis Software SL
Manual de Usuario r2 esp
URL http://www.intesis.com
Email info@intesis.com
tel +34 938047134
57 / 65