Electrolux Y63IV443 Manual De Instrucciones página 57

2. To deactivate the function: press
The previous heat setting comes on.
6.11 Lock
You can lock the control panel while cooking
zones operate. It prevents an accidental
change of the heat setting.
Set the heat setting first.
To activate the function: touch
comes on for 4 seconds. The Timer stays on.
To deactivate the function: touch
previous heat setting comes on.
When you deactivate the hob, you also
deactivate this function.
6.12 Child Safety Device
This function prevents an accidental
operation of the hob.
To activate the function: activate the hob
with . Do not set any heat setting. Touch
for 4 seconds.
the hob with .
To deactivate the function: activate the hob
with . Do not set any heat setting. Touch
for 4 seconds.
the hob with .
To override the function for only one
cooking time: activate the hob with
comes on. Touch
heat setting in 10 seconds. You can
operate the hob. When you deactivate the
hob with the function operates again.
6.13 OffSound Control (Deactivating
and activating the sounds)
Deactivate the hob. Touch
The display comes on and goes out. Touch
for 3 seconds.
of the timer to choose one of the following:
• - the sounds are off
.
. The
comes on. Deactivate
comes on. Deactivate
.
for 4 seconds. Set the
for 3 seconds.
or comes on. Touch
. • - the sounds are on
To confirm your selection wait until the hob
deactivates automatically.
When the function is set to
the sounds only when:
• you touch
• Minute Minder comes down
• Count Down Timer comes down
• you put something on the control panel.
6.14 Power management
If multiple zones are active and the
consumed power exceeds the limitation of the
power supply, this function divides the
available power between all cooking zones
(connected to the same phase). The hob
controls heat settings to protect the fuses of
the house installation.
• Cooking zones are grouped according to
the location and number of the phases in
the hob. Each phase has a maximum
electricity loading (3700 W). If the hob
reaches the limit of maximum available
power within one phase, the power of the
cooking zones will be automatically
reduced.
• The heat setting of the cooking zone
selected last is always prioritised. The
remaining power will be divided between
the previously activated cooking zones in
reverse order of selection.
• The heat setting display of the reduced
zones changes between the initially
selected heat setting and the reduced heat
setting.
• Wait until the display stops flashing or
reduce the heat setting of the cooking
zone selected last. The cooking zones will
continue operating with the reduced heat
setting. Change the heat settings of the
cooking zones manually, if necessary.
Refer to the illustration for possible
combinations in which power can be
distributed among the cooking zones.
you can hear
ENGLISH 57