Alpina SF-5032 Instrucciones De Uso página 6

ENGLISH
1. Change to one of the shorter combs 3mm or 6mm, trim sideburns, i.e.
the hair directly in front of the ears. Then change to one of the linger
combs, 9mm or 12mm, and continue to cut to the top of the head.
(Diagram 3)
1. Using comb attachment 9mm or 12mm, cut top of head from back to
front against the direction in which the hair normally grows (Diagram
4). In some cases, this may require the reverse, or cutting from front
to back.
2. Comb attachments 3mm or 6mm are used to achieve a close crew cut
or short cut.
3. For longer hair on top, use the comb provided and lift hair on the top of
the head. Cut over the comb, with the hair lifted or hold the hair
between the fingers to lift it and cut it to desired length (Diagrams 5 &
6). Always work form the back of the head. You can cut the hair
shorter gradually by reducing the space between the comb/fingers, and
the head. Comb out trimmed hair and check for uneven strands.
Diagram 5
1. Finally, use the taper lever without an attachment comb for close trimming around the base of the
neck, the sides of the neck and the ears.
2. To produce a clean straight line at the sideburns, reverse the hair clipper by turning the reverse side
uppermost. (Diagram 7)
3. Press the clipper at right angles to the head, tips of the blades lightly touching the skin and work
downwards. This way you will obtain, as a clean cut as would be given by a razor.
STEP 3 – SIDE OF THE HEAD
STEP 4 – TOP OF THE HEAD
Diagram 6
STEP 5 – THE FINISHING TOUCH
- 6 -
Diagram 3
Diagram 4
Diagram 7