Publicidad
Idiomas disponibles
Idiomas disponibles
GB
MT
Restrictor
Place the restrictor (19) on the blow-off
pipe (
1). Use the restrictor (19) to
obtain selective heat, e.g. to seal plastics
(films, shrink tubing).
When using the restrictor (19),
pay particular attention to the heat
development at the cutting point. If
in doubt, do not stay in the same
place for too long in order to avoid
overheating the workpiece.
Surface nozzle
Place the surface nozzle (17) on the blow-
off pipe (
1).
Use the surface nozzle (17) to obtain heat
over a large surface.
It is especially suitable for dissolving adhe-
sive or softening paints.
When using the surface nozzle
(17), pay particular attention to the
heat development in adjacent loca-
tions of the cutting point. So that in
cases of doubt, no adjacent compo-
nent is overheated.
Spatula nozzle
Place the spatula nozzle (18) on the blow-
off pipe (
1).
The spatula form of the nozzle serves the
purpose of the targeted hot air supply to
paint and lacquer surfaces. The paints and
lacquers can be removed with a spatula
and scraper. The spatula (18) itself is not
suitable for removing paint.
22
Grill lighter nozzle
Place the grill lighter nozzle (15) on the
blow-off pipe (
1).
Change the device with the step switch
(
5) to level "3". Place the grill lighter
nozzle (15) below the charcoal. Make sure
that the openings of the grill lighter noz-
zle (15) are not covered by charcoal as
this creates heat accumulation in the unit,
which is a potential fire hazard In just a
few minutes the charcoal is ignited.
Never use other methods for ignit-
ing charcoal at the same time while
using the grill lighter nozzle (15).
Use the grill lighter nozzle (15) only
for the few minutes necessary to
ignite the charcoal.
Never use the grill lighter nozzle
(15) for any other application.
Conical nozzle
For use as a weed killer, the device
may only be operated with the
extension pipe. When eliminating
weeds, hold the device by the
handle on the extension.
Place the conical nozzle (16) on the
blow-off pipe (
1).
Use the conical nozzle (16) to remove
weeds.
To eliminate weeds, use the conical
nozzle on the plant to be removed
for approx. 5-10 seconds.
For higher plants, you can shrink
them by briefly heating the upper
part of the plant. Then, use the coni-
Publicidad
