Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
2. Connecting the Spray Wand to the Handle
a. Make sure the O-ring is in place inside the end
cap.
b. Thread the end cap of the spray wand (G) onto
the handle (H) and tighten securely.
c. Rotate the spray wand until the nozzle is
aligned with the handle (pointing down) and
ready for use.
d. Pull on the spray wand to be sure it is properly
secured.
3. Connecting the Hose to the Handle
a. Thread the end cap of the hose (F) onto the
end of the handle (H).
b. Hand-tighten the end cap. Do not overtighten.
c. Make sure the connection is secure.
d. Attach the assemble area to the wand clips (I)
on either side of the sprayer.
4. Filling the Tank
Liquid chemicals to be sprayed must be as thin as
water. Thicker liquids will not spray properly. Do
not overfill the tank.
a. Remove the battery pack.
b. Unscrew the tank cap (A) and remove it from
the tank.
c. Fill the tank (B) with the desired amount of
water.
d. Measure the recommended amount of liquid
chemical.
e. Carefully pour the liquid chemical into the tank.
f.
Screw the cap (A) back onto the sprayer,
making sure it is tightened securely.
Spray solutions may be premixed and poured into
the sprayer.
NOTICE: If using a measuring container to hold the liquid, be sure to thoroughly clean and rinse
the container after use. If premixing the spray solution, rinse the container used for mixing.
NOTICE: It is important to thoroughly clean the sprayer after each use. Allowing liquid to
remain in an idle sprayer for an extended period of time may cause its moving pieces and
connectors to seize up.
2
O-ring (Ø6.8x3mm)
G
End cap
3
4
B
10
H
H
End cap
F
Publicidad
