Descargar Imprimir esta página

Delta 36-422L Manual De Instrucciones página 9

Publicidad

Idiomas disponibles

Idiomas disponibles

ATTACHING THE DUST BAG
1. Attach the dust spout (A) Fig. 3 to the dust port (B).
2. Depress the spring clips (C) Fig. 3 of dust bag (D) and clip the dust bag (D) over the rib of the dust spout (A).
MOVING THE CUTTINGHEAD TO THE UP POSITION
Push down on the handle (B) Fig. 4. Pull out the cutting-head lockpin and move the cuttinghead (B) to the up
position.
C
D
Fig. 3
NOTE: The tension of the cuttinghead return spring has been adjusted at the factory so that the cuttinghead returns to the "up"
position after a cut has been made. If the head fails to return properly, please take the tool to your nearest authorized service
center for service.
ATTACHING THE DUST SHROUD
With the cuttinghead in the up position, attach the dust
shroud (A) Fig. 4A to the port (B) with three screws using
the supplied wrench.
NOTE: Installation is easier if you place a screw on the
wrench and then place it in the hole.
MOVING THE TABLE TO THE 0° CUT-OFF POSITION
1.
Rotate the locking knob (A) Fig. 5 counter-clockwise as far as it will go. Depress the lever (B) and rotate the table
(C) to the 0° straight cut-off position, release the lever (B), and tighten the locking knob (A).
NOTE: This saw incorporates a new slotted plate design feature (D) Fig. 6 with location adjustment screws (E) for
fine-adjusting the cutting angle.
2.
For proper operation and adjustment of the table, refer to sections, "ROTATING TABLE FOR MITER CUTTING",
and "ADJUSTING SLIDING FIT BETWEEN MOVABLE TABLE AND BASE.
A
A
B
B
C
Fig. 5
B
Fig. 4
A
E
9
A
B
Fig. 4A
E
D
Fig. 6

Publicidad

loading

Este manual también es adecuado para:

36-422l-ca