Appendix; Operating The Tv With The Player's Remote Control - Pioneer DCS-222K Manual De Instrucciones

7

Appendix

Operating the TV with
the player's remote
control
When the manufacturer code for your
brand of TV is set on the player's remote
control, the TV can be operated using the
player's remote control.
CAUTION
• For some models it may not be possible
to operate the TV with the player's remote
control, even for TVs of brands listed on the
manufacturer code list.
• The setting may be restored to the default
after the batteries are replaced. If this
happens, reset it.
1. Input the 2-digit manufacturer code.
Press the number buttons (0 to 9)
to input the code while pressing TV
CONTROL .
NOTE
• The factory default setting is 00
(PIONEER).
• If you make a mistake when inputting the
code, release TV CONTROL  then start
over from the beginning.
• When there are multiple codes for a
manufacturer, try inputting them in
the indicated order until the TV can be
operated.
2. Check that the TV can be operated.
Operate the TV using TV CONTROL .
 – Press to turn the TV's power on and
off.
INPUT SELECT – Press to switch the TV's
input.
CH +/– – Press to select the TV channel.
VOL +/– – Press to adjust the volume.
Appendix 41
7