Video Setup; Speaker Setup; Digital Setup - KDX R-091 Manual Del Usuario

4.20.4 VIDEO SETUP

BRIGHTNESS
It is for adjusting the brightness of the video output.
CONTRAST
It is for adjusting the contrast of the video output.
HUE
It is for adjusting the hue of the video output.
SATURATION
It is for adjusting the saturation of the video output.
SHARPNESS
It is for adjusting the sharpness of the video output.

4.20.5 SPEAKER SETUP

DOWNMIX
It is for selecting your desired sound effect when there is no center speaker and subwoofer. There are 3
modes: LT/RT, STEREO, VSS.
LT/RT
When playing a disc with PRO LOGIC Dolby stereo effect, choose the item, so it will output audio signal with
vivid theatre effect.
STEREO
If you choose the item, when outputting audio signal with 5.1 channels, it will output the left and right
channels of signal ; when outputting audio signal with 2 channels, it will output the common 2 channels of
stereo signal.
VSS
If you choose the item, when playing a disc recorded with 5.1 channels, the main channel speakers can
output audio signal with VSS effect.

4.20.6 DIGITAL SETUP

DYNAMIC RANGE
After selecting the compression mode of LINE OUT, set the item, so you
can adjust the linear compression ratio. If you set it to be FULL, the
Peak-to-Peak value of the audio signal is the minimum; if you set it to be
OFF, the Peak-to-Peak value is the maximum.
DUAL MONO
It is for selecting a desired audio output mode for the left and right ways
of signal. It is mainly for Karaoke of Ac3. There are 4 modes in all as follows: STEREO, MONO L, MONO R,
MIX MONO.
- 15 -