Publicidad
Idiomas disponibles
Idiomas disponibles
Always adhere to these regulations and to the locally prevailing safety regulations, and proceed very
carefully.
Inform all people involved in the activities of the operation about these safety regulations.
2.2
Model plate and CE marking on the equipment
Refer to Fig. 1.
All pictograms attached to the equipment pertaining to safety and danger must be complied with and
remain clearly legible.
WARNING
Not following these instructions can result in serious personal injury, fatal accident, damage
to the system or consequential loss.
/i
Type of mark
Position
Ban
A
Model plate
B
2.3
General safety regulations
•
Use this equipment solely for the activities for which it was designed. If you are in doubt or
uncertain, always consult your Holmatro dealer.
•
Replace illegible safety symbols, pictograms and information labels with identical ones, available
from your Holmatro dealer.
•
Varnished, plastic and rubber parts are not resistant to corrosive acid or liquid. Except for electrical
parts, rinse parts that have come into contact with corrosive acid or liquid with a lot of water. Consult
your Holmatro dealer for a resistance list.
•
Prevent dirt in and on the couplers.
•
Protect equipment against sparks during welding or grinding activities.
•
Avoid an unhealthy posture while working. It can result in physical complaints.
•
Follow the inspection and maintenance instructions.
•
Conversion of the piece of equipment or the system may only be performed by a Holmatro Certified
Technician. In case of a conversion, retain the original manual and the conversion manual.
•
Use only genuine Holmatro parts and maintenance products prescribed by Holmatro.
2.4
Personal safety
Personnel that uses or assists in the use of the equipment must wear all personal means of protection
as prescribed in the standard work procedure. Negligent use of personal means of protection can result
in serious injury. During use wear at least the following personal means of protection:
•
Helmet;
•
Safety goggles or full face shield;
•
Safety gloves;
•
Safety clothing for the entire body;
•
Safety shoes with good ankle support and toe protection.
2.5
Safety regulations with respect to the equipment
•
Support only on the ribbed part of the spreading arm.
•
The load must not be supported at the side of the spreading arms only but over the entire width.
HW
Description
Never work under or between the load.
Manufacturer's information stating: name,
address, CE marking, model indication, serial
number and date of construction, maximum
operating pressure.
916.219.177_004
EN
Part number
-
-
19
Publicidad
