bosal 017-682 Instrucciones De Servicio Y Montaje página 19

The fact that the towing bracket has been mounted to the vehicle must be entered in the
vehicle papers at the next possible opportunity. The mounting instructions must be added to
the vehicle papers.
General Installation Intructions:
If present, remove insulating compound and/or underseal in the area of the towing bracket
contact surfaces. Coat bare bodywork with anti-corrosion paint.
Mount 7-pin electrical system as per DINV 72570.
Mount 13-pin electrical system as per ISO 11446.
Retighten all mounting bolts of the towing bracket after aprox. 1000 towing km. Please note,
that after mounting the drawbar the mass of your vehicle will change.
Mounting instructions:
Lower the exhauster then remove the ablation plate.
–
According to drawing loosely fix the side plates (2,3) to the internal side of the
–
chassis beam at the „a" positions with the attached bonding units.
According to drawing loosely fix the drag hook body (1) to the side plates at the „b"
–
positions with the attached bonding units.
Adjust the drag hook into mid-position then tighten all the bolts.
–
Reinstall the ablation plate and hang on the exhauster.
–
According to requirements carry out connecting of electric wires breaking the rear sheaf of
–
cables.
Only specialised services are authorised to install drawhooks.
–
19