Satelec Mini L.E.D Manual De Instrucciones página 6

4 – PRODUCT DESCRIPTION
Now that the Mini L.E.D. is fully charged,
you need to familiarize yourself with its
buttons and menus:
1
2
Handpiece (1):
LED indicators:
The handpiece has four LEDs:
one status LED close to the light guide
-
indicating the following:
Color
Green Normal mode
Red Battery low
Red flashing Thermal protection
three LEDs in line
-
selected curing mode:
Color
Red Fast Curing
Orange Pulse curing
Yellow Step curing
Buttons:
The handpiece has two buttons:
- one navigation button which is used to
switch from one menu to another
One on/off light button (trigger) close
-
to the light guide.
Base station (2):
Radiometer:
A built-in radiometer, associated with a
LED indicator allows the operator to check
accurately the curing unit's performance.
The aperture is located on the front part
of the base station.
To proceed:
-
-
-
LED indicator:
Color
Green
Red
Charge:
When the handpiece is inserted in the base
station, another LED displays the charge
status for the battery:
Green flashing
Green
5 – MENUS
The Mini L.E.D. has three different menus.
Mode
To select the menu you want to use, press
the navigation button.
Fast Curing Menu: when the handpiece is
removed from the base station, the unit
showing the
will be set on fast curing program for 10
seconds. The red light indicates your
Mode
selection.
In this mode the power provided by your
unit is approx.:
- 1100mW/cm² (± 10%) with the Ø7.5mm
standard light guide.
- 2000mW/cm² (± 10%) with the Ø5.5mm
optional booster Tip.
6
Set the unit in Fast Curing mode.
Insert the standard light guide into the
hand piece after checking no VLC
material remains on the light guide.
Place the end of the light guide in the
aperture and activate the Mini L.E.D.
Mode
Power over 800mW/cm²
See troubleshooting chapter
Color Mode
Charging
Battery fully charged