Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE FIRST USE
Remove protective rubber jams before
using the scale. (For EK8012 only)
For EK8012 only
TO REPLACE BATTERY
1x3V lithium battery (CR2032). Please
remove the isolation sheet from the
battery contact before use.
or 2 PCS AAA batteries (not included)
a.Open battery case cover on the back of scale.
b.Take out the used batteries (with the aid of a
sharp object, if needed)
c.Install new battery by putting one side of the
battery and then pressing down the other side.
Please take note to the polarity.
TO OPERATE SCALE
1. Please put the scale on a hard and flat
surface.
2. Place bowl (if used) on the scale before
turning on the unit.
3. Press and release ON/OFF button to turn
on the unit.
4. Wait until display prompts to '0' before
starting weighing.
TO CONVERT WEIGHT UNITS
If the scale is with both measuring system of
Metric (kilograms, grams) and Imperial (pounds,
ounces), you can press UNIT to convert between
two systems during the course of weighing.
Remark: The unit system of scale depends on
sales destination or the requirement of distributor.
"ZERO" or "TARE" function
To weigh different loads consecutively without removing loads from the scale.
Put first load on the scale, get weight reading. Press Z/T button to reset
the LCD reading to '0' before adding next load. You can repeat this operation.
Condition 1:"ZERO" function
When total sum of all loads on scale
4% of scale's max capacity.
(4%=80g when capacity is 2kg;
200g when capacity is 5kg)
LCD will show '0g' each time Z/T is pressed.
Icon '0' will show on left lower corner of LCD,
indicating 'ZERO' function is active.
Max.weight capacity remains unchanged.
Condition 2: "TARE" function
When total sum of all loads on scale
> 4% of scale's max capacity.
(4%=80g when capacity is 2kg;
200g when capacity is 5kg)
LCD will show '0g' each time Z/T is pressed.
Icon 'TARE' will show on left upper corner of
LCD, indicating 'TARE' function is active.
Max.weight capacity is reduced by total weight
of all loads.
Under this condition:
By pressing Z/T, you can see the total weight
of all loads on the scale. If you want to weigh
more loads, just press Z/T to reset LCD
reading to '0' again.
Publicidad
