ExecutiveSafe CS-2 Manual De Usuario página 4

Programming the Master Code
For your safety, please program the master code before start using the safe.
Open the door, press "0" two times and then press once the red push button located at the back of
the door. See Fig. 3.
The yellow LED marked READY will go on followed by 2 short buzzer beeps.
Enter your new Master code (3-8 digits) followed by the "A" or "B" key.
The marked READY yellow LED will go off followed by two short buzzer beeps to indicate that
the new Master code has been accepted and stored.
The previous programmed master code is deleted.
If the yellow LED flushes three times followed by three buzzer beeps then the programming of the
master code needs to be repeated.
Test the master code you just programmed with the door open.
Programming your combination
Open the door, press once the red push button located at the back of the door. See Fig. 3.
The yellow LED marked READY will go on followed by 2 short buzzer beeps.
Enter your new Combination (3-8 digits) followed by the "A" or "B" key.
The marked READY yellow LED will go off followed by two short buzzer beeps to indicate that
the new Combination code has been accepted and stored.
The previous programmed combination code is deleted.
If the yellow Led flushes three times followed by three buzzer beeps then the programming of the
combination code needs to be repeated.
Test the combination you just programmed with the door open.
Fig.3