Publicidad
Idiomas disponibles
Idiomas disponibles
BATTERY CHARGER
W A R N I N G
If the battery is inserted into the charger when warm or hot, the CHARGING LED indicator
light on the charger may switch on and illuminate RED. If this occurs allow the battery to cool
inside of the charger for up to 30 minutes. Charging should automatically start once battery has
cooled.
CHARGER MOUNTING
1. This charger can be installed hanging on a wall using two #8 screws (not included ).
2. Locate the placement for the charger to be wall mounted.
3. If fastening to wood studs use 2 wood screws (not included ).
4. Drill two holes on center 4.5 in. apart ensuring that they are vertically aligned.
5. If fastening to drywall use wall anchors (not included) and screws to secure the charger
to the wall.
Note: If the battery and the charger won't be used for a long time, remove the battery from
the charger and pull out the AC power plug.
CLEANING
1. Remove the battery
• Brush or blow dust and debris out of the air vents using compressed air or a vacuum.
Keep the air vents free of obstructions. Do not spray, wash, or immerse the air vents in
water.
• Wipe off the housing and the plastic components using a dry, soft cloth. Do not use strong
solvents or detergents on the plastic housing or plastic components. Certain household
cleaners may cause damage and may cause a shock hazard.
2. Battery
• Fully charge the battery.
• Once the charging light turns green, remove the battery from the charger and disconnect
the charger from the outlet.
• After charging, the battery may be stored in the charger as long as the charger is not
plugged in.
7
Publicidad
