Gabarron ADS Serie Instrucciones De Instalacion Y Uso página 8

3.- Take off the front panel by removing the two screws at the bottom of the heater (fig 2).
fig 2
4.- Set the heater in the selected installation area and mark the fixing points on the wall using a pencil. Use the heater fixing
holes as a template and mark the wall through the fixing holes. Drill the required holes into the wall.
5.- Fix the heater to the wall. Please note the weight of the heater is taken by the feet, the wall fixing screws are only to
prevent the heater overturning. If there is any doubt as to the strength of the wall please consult an expert. Storage
heaters are very heavy and the installer must ensure that they are securely fixed and that there is no
possibility of them overturning.
6.- Connect the heater using the enclosed wiring diagram. Ensure that all connections are firm. Use silicone covered wire. Do
not leave any remaining wire inside the heater.
7.- Remove the inner front panel with the attached convector element.
Warning!
At the other side of this front panel there is a breakable thermal insulation panel. Both sides must be handled with care. Avoid
touching the insulation and the convector element.
8.- Do not disconnect the electrical elements. Remove the packaging then lift and recline the elements.
9.- Place the storage bricks carefully, with the flat side facing the back of the heater. Arrange two rows of bricks (fig 3). Should
big bricks (ref 2072) are required they must be placed at the right side.
fig 4
fig 3