Makita 4100NH2 Manual De Instrucciones página 7

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing diamond wheel
1
2
009563
Hold the outer flange with the wrench and loosen the hex
bolt clockwise with the hex wrench. Then remove the
hex bolt, outer flange and diamond wheel.
To install the wheel, follow the removal procedure in reverse.
Always install the wheel so that the arrow on the wheel points
in the same direction as the arrow on the blade case.
BE SURE TO TIGHTEN THE HEX BOLT SECURELY.
1
2
009565
CAUTION:
Use only the Makita wrench and hex wrench to
•
install or remove the wheel.
OPERATION
009561
Hold the tool firmly. Set the base plate on the workpiece to be
cut without the wheel making any contact. Then turn the tool on
and wait until the wheel attains full speed. Now simply move the
tool forward over the workpiece surface, keeping it flat and
advancing smoothly until the cutting is completed. Keep your
1. Outer flange
2. Wrench
3. Hex wrench
3
1. Inner flange
2. Diamond wheel
3. Outer flange
3
4. Hex bolt
4
cutting line straight and your speed of advance uniform.
CAUTION:
This tool should only be used on horizontal
•
surfaces.
Be sure to move the tool forward in a straight line
•
and gently. Forcing and exerting excessive
pressure or allowing the wheel to bend, pinch or
twist in the cut can cause overheating of the motor
and dangerous kickback of the tool.
When using a curving diamond wheel
(optional accessory)
WARNING:
Failure to follow the following warnings may result
in serious injury.
Mount the diamond wheel on the spindle of the tool
•
making sure that the direction of arrow on the
surface of the diamond wheel matches the direction
of the arrow on the blade case of the tool.
Always wear the safety goggles or safety glasses.
•
The rated speed of the diamond wheel must be at
•
least equal to the maximum speed marked on the
power tool. Diamond wheels running faster than
their rated speed can break and fly apart.
Before each use, make sure with hands and eyes
•
that the diamond wheel has no deformation, cracks,
chips, breaking, or abnormal tear and wear on the
cutting edge and the body of the diamond wheel.
Stop using the diamond wheel once you find such
•
abnormal signs.
Perform cuts according to the shape of the curving
•
diamond wheel.
Do not obtain your desired cutting depth at a time
•
but make several adjustments by setting for the
small amount cutting depth
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
After use
Blow away dust from the inside of the tool by running the
tool at an idle for a while. Brush off accumulation of dust
on the base. Accumulation of dust in the motor or on the
base may cause a malfunction of the tool.
7